46
Passage Mode configuration
x1R Smart Passage Mode (also called Office Mode), can be se in 2 different ways:
Light: the lock withdraws the bolts, and keeps closed only by the latch. Opening with
authorized credentials withdraws only the latch, allowing energy saving and less
mechanical wear. This is set as default from the factory.
Free: the lock withdraws the bolts and holds back the latch. In this mode the door is always
opened for any user who wishes to gain access, without the use of authorized credentials.
Light mode (set as default from the factory).
In the electronic motorized locks for armoured doors market, used in offices aplications (common
doors with high transit of people), the door should not be always opened (Free), but closed only
with the latch. This state is called “Light”, just because the lock, not closing the bolts, is not
completely secure. This solution is however very useful and effective in these contexts since it has
the following advantages:
high battery saving;
reduced mechanical wear of lock, bolts, rods and deviators;
higher opening speed;
less noise during opening and closing movement.
To Next Page
Loading...
Need help?
General
