62
Appendix
Events log messages
(Specific for x1RSmart)
Close with Mechanical Key
Lock closed by mechanical key.
The Scheduled Passage Mode has been enabled, disabled or
changed.
Open delayed due to battery in status very low.
Close delayed due to battery in status very low.
The lock has been opened by any authorized credential (phone,
card, tag or PIN), or by an external command (internal control
module or remote opening command).
Door closed, x1R bolts automatically close. Maximum security.
Door closed with Light Mode enabled. Only latch in, bolts not out.
The functional mode Outside Knob/Outside Handle has changed.
This function is only available on x1R Smart Standard.
Lock bolts in half-way by handle
Lock bolts in half-way by handle
Lock bolts in half-way by key
Bolts have been moved by key but not completely in. Just 1 shot
Lock not close due to motor
It happens when there is an excessive friction of latch or bolts
Lock not close due to sensor
It may happen when motor does not engage the mechanic during
Lock not open due to motor
It happens when there is an excessive friction of latch or bolts
Lock not open due to sensor
It may happen when motor does not engage the mechanic during
Open with Internal Handle
Lock opened from the inside by the internal handle.
Lock opened by mechanical key.
Open by remote opening button
Lock opened by remote opening button.
Open denied due to internal handle
It happens when, opening by any electrical command, the internal
handle is slightly down enough to activate its internal sensor. It
may happen for example in case of x1R combined with panic bar
device, if installation has not been correctly done the weight of the
bar could cause this issue.
To Next Page
Loading...
Need help?
General
