53
Door sensor contact in the hinge side of the door
It is possible to install the female Door sensor contact also in the hinge side of the door frame. To
do that it is necessary to order a specific x1R Smart product code without the male Door sensor
contact embedded in the lock (not standard solution). This code includes an additional male Door
sensor contact, with adjustable spring contacts, to be installed in the hinge side of the door and to
be connected to a 2 pin dedicated connector, placed into the x1R Smart electronic board (see
Electrical connection paragraph).
Female door sensor
contact.
To be installed in the
fixed door frame, in
the hinge side.
Male door sensor contact:
with adjustable spring
contacts, installed in the
hinge side of the door.
2 Poles connector.
To be connected to x1R Smart.
1. Female Door sensor contact to get the
door “ajar status”. It is installed in the
hinge side of the door. Connect the male
door sensor contact to the 2 poles
connector, available in back of the lock.
3. Power supply (8-30Vdc – optional).
It is always possible to power the lock by
the female Door sensor contact, installed in
the hinge side door.
4. Alkaline batteries (6x1,5V type “D”).
Mandatory in case of power supply by
door sensor contact.
With the Door sensor contact in the “hinge side of the door solution”, pay attention
to properly regulate the contacts, in order to avoid that lock bolts starts when the
door is yet not fully closed (ajar).
2. x1R Smart special version (not standard),
without the male Door sensor contact
embedded in the lock.
To Next Page
Loading...
Need help?
General
