[Error content] Label could not be pasted to the commodity.
[Detail] Pasting timing signal was not received.
[Solution] [RETURN] button
[Remarks]
Pasting is carried out by the pasting timing signal sent from board
P-920 and received by P-916. This signal was not received.
[Cause] Pasting timing signal from board P-920 was not received.
[Response]
1. Cable disconnected between P-920（XJ35） -> P-916（XJ-18）.
2. Replace board P-920
3. Replace board P-916
0612
Ishida WM-4000 Error Codes and Solutions (600-2099)
To Next Page
Loading...
