ISHIDA WM-4000 - 1504: The Power Failure Occurred by Console

[Error content] Tray detector (P-915) detected power OFF in the console.
[Detail] Power ON command received twice from the console.
[Solution] Restore power
[Remarks]
[Cause] Board P-910 was reset twice
[Response]
Restore power. Consider the following causes if the same error
occurs:
1）Unstable power unit input (AC 200V)
2）Check power unit output voltage (DC 24V)
Power unit location
1504
Ishida WM-4000 Error Codes and Solutions (600-2099)
March 2015
54/84