ISHIDA WM-4000 - Tray Detection Control Part Errors; 1503: The Problem Arose in the Tray Detector

[Error content]
The command sent to the tray detector and the command in the
response message are different.
[Detail]
[Solution] Restore power
[Remarks]
[Cause]
The command sent to the tray detector and the command in the
response message are different.
[Response]
1. Restore power.
2. If the same error occurs, check P-915 (XJ-7) voltage (DC 24V).
1503
Ishida WM-4000 Error Codes and Solutions (600-2099)
March 2015
53/84