ISHIDA WM-4000 User Manual

[Error content] Threshold has not been set.
[Detail] Need to adjust detector in test mode.
[Solution]
[OK] -> Operate without detector.
(Operate with registered trays)
[Remarks]
[Cause] Threshold has not been set.
[Response]
1. Perform "Initialize detector" in Test Mode -> Adjust Camera
Position (mode 3).
2. If the error re-occurs, P-915 is malfunctioning.
1507
Ishida WM-4000 Error Codes and Solutions (600-2099)
March 2015
57/84

ISHIDA WM-4000 Specifications

General

Brand	ISHIDA
Model	WM-4000
Category	Industrial Equipment
Language	English