ISHIDA WM-4000 User Manual

[Error content] The applicator sensor is unusual.
[Detail]
A sensor that does not have light blocked is blocked from light.
[Sub-error]
-000 X axis
-010 Y axis
-020 Z axis
[Solution] [RETURN] button
[Remarks]
[Cause] A sensor that does not have light blocked is blocked from light
[Response]
[Sub-error]
-000 Check the X axis sensor (Is it blocked from light even though
there is no detection board?)
-010 Check the Y axis sensor (Is it blocked from light even though
there is no detection board?)
-020 Check the Z axis sensor (Is it blocked from light even though
there is no detection board?)
0616
Ishida WM-4000 Error Codes and Solutions (600-2099)
March 2015
19/84

ISHIDA WM-4000 Specifications

General

Brand	ISHIDA
Model	WM-4000
Category	Industrial Equipment
Language	English