ISHIDA WM-4000 User Manual

[Error content] Applicator CPU was reset.
[Detail]
Before receiving the acknowledge power ON command, the applicator
received a different command
[Solution] Restore power
[Remarks]
[Cause] Board P-916 was reset
[Response]
Restore power. If the same error occurs, consider the following
causes:
1）Power unit (U1) input power (AC 200V) is unstable
2）Check output voltage (DC 24V) of power unit (U1)
0605
Ishida WM-4000 Error Codes and Solutions (600-2099)
March 2015
7/84

ISHIDA WM-4000 Specifications

General

Brand	ISHIDA
Model	WM-4000
Category	Industrial Equipment
Language	English