3-10
PRE-DRIVING OPERATIONS AND ADJUSTMENTS
Stopping the Anti-theft System Alarm
To stop the anti-theft system alarm (horn and hazard warning flasher), perform either of
the following operations:
• Push the engine start/stop button to switch the power mode to "ON" (models with
passive entry and start system).
• Insert the key into the starter switch and turn it to the "ON" position (models with
keyless entry system).
• Operate the remote control unit.
5108428_sec03_PRE-DRIVING OPERATIONS.indd 10 2020/11/06 10:49:00
To Next Page
Loading...
Need help?
General
