3-125
PRE-DRIVING OPERATIONS AND ADJUSTMENTS
To Enable the Passenger Side SRS Airbag
1. Insert the key into the passenger side
SRS airbag on-off switch and turn it to
the "ON" position.
2. Leave it in the "ON" position and
remove the key.
NOTE
• In models with a passive entry and
start system, use the mechanical
key stored in the electronic key.
NOTE
• Operate the switch when the power mode is "OFF" (models with passive entry
and start system) or the starter switch is in the "LOCK" position (models without
passive entry and start system).
3. When the power mode is switched to
"ON" (models with passive entry and
start system) or the starter switch is
turned to the "ON" position (models
without passive entry and start
system), ensure that the passenger
side SRS airbag ON indicator light
comes on. While the switch is in the
"ON" position, the passenger side
SRS airbag ON indicator light stays
lit.
Passenger side SRS airbag ON
indicator light
5108428_sec03_PRE-DRIVING OPERATIONS.indd 125 2020/11/06 10:49:15
To Next Page
Loading...
Need help?
General
