4-119
CONTROLS AND INSTRUMENTS
Models with Automatic Headlight
Automatic headlight can be used when the power mode is "ON" (models with passive
entry and start system) or the starter switch is in the "ON" position (models without
passive entry and start system). When the light control switch is in the "AUTO" position,
the lights come on or go out automatically depending on the brightness outside the
vehicle.
Settings (User Customization Function)
→Refertopage 4-46
Display indication Description
Light
Auto light
sensitivity
0
The sensitivity of the automatic
headlight can be set to 4 levels:
0 (low) - 3 (High)
1
2
3
Name
Brightness outside the vehicle
Bright Dim Dark
Headlight Off Off On
Clearance light/taillight/license
plate light
Off On On
The settings of the automatic headlight can be changed by using the user
customization function on the MID.
NOTE
• When the light control switch is in
the "AUTO" position, if the outside
of the vehicle is dark (inside a long
tunnel, congestion in a tunnel,
indoor parking lot etc.), the lights
may not go out immediately even
after the outside of the vehicle
becomes brighter. In this case,
the lights will go out when the light
control switch is turned to the "OFF"
position.
NOTE (Continued)
5108428_sec04_CONTROLS AND INSTRUMENTS_P001-142.indd 119 2020/11/09 14:07:03
To Next Page
Loading...
Need help?
General
