Isuzu D-MAX 2020 - Page 399

4-123
CONTROLS AND INSTRUMENTS
Models with Coming Home Light
This function turns on the headlights (low
beam) and clearance lights to enhance
safety after leaving the vehicle.
When the power mode is "OFF" (models
with passive entry and start system) or
the starter switch is in the "LOCK" position
(models without passive entry and start
system) and the light control switch is
set to the "OFF" or "AUTO" position, the
headlights and clearance lights turn on
for approximately 30 seconds if the light
control switch lever is pulled lightly.
When lights come on, the light position
indicator light and the high beam indicator
light located on the instrument panel come
on.
The settings of the coming home light can
be changed. Contact the nearest Isuzu
Dealer for details.
The settings of the coming home light
can be changed by using the user
customization function on the MID.
Settings (User Customization Function)
 →Refertopage 4-46
RTUL40SH044001
NOTE
• Do one of the following operations while the lights are on to turn off the lights.
- Move the lever forward again.
- Switch the power mode to "ON" (models with passive entry and start system)
or turn the starter switch to the "ON" position (models without passive entry
and start system).
Light position indicator light
High beam indicator light
Display indication Description
Light
Coming home
light
Enable
Turns on the coming home
light.
Disable
Turns off the coming home
light.
5108428_sec04_CONTROLS AND INSTRUMENTS_P001-142.indd 123 2020/11/09 14:07:03