4-167
CONTROLS AND INSTRUMENTS
NOTE
• If the engine is turned off and then
restarted again while the TCS is
off, the TCS will be automatically
reactivated.
ESC OFF indicator light
When Canceling the ESC
When the ESC is active after the engine
is started, press the ESC OFF switch for
approximately 5 seconds to cancel the ESC
and cause the ESC OFF indicator light in
the instrument panel to turn on. When the
switch is pressed again for approximately
1 second, the ESC function turns back on.
CAUTION
• When you turn off the ESC, it will
not be available to assist you in
slippery driving conditions. Always
use caution when driving on slippery
roads.
• Be sure to enable the ESC during
normal driving.
• When the ESC is turned off, the
TCS will also be turned off, thus
be careful when driving on slippery
roads.
NOTE
• If the engine is turned off and then
restarted again while the ESC is
off, the ESC will be automatically
reactivated.
• When the 4WD switch is set to 4L
(4WD low) (models with 4WD), the
ESC will be canceled automatically.
5108428_sec04_CONTROLS AND INSTRUMENTS_P143-end.indd 167 2020/11/12 15:28:57
To Next Page
Loading...
Need help?
General
