7
Menus
The action keys are used to display and activate various commands for operating and configuring the system.
The principal menus are shown below:
Press the 0 (zero) key when no tests are
running and no other menu is active.
Press the 6 key while the Main Menu is
displayed.
Press the 5 key while the Configuration
Menu is displayed, enter the supervisor
PIN at the prompt, then press and hold
the Enter key.
Press the 6 key while the Supervisor
Menu is displayed.
Press the 7 key while the Supervisor
Menu is displayed.
Press the QC key while a cuvette is
inserted in the instrument.
Press the QC key before a cuvette is
inserted in the instrument
(or, select 4 from the QC Selects menu.)
Press the NOTE key after a cuvette is
inserted in the instrument.
Press the ID key while a cuvette is
inserted in the instrument.
Press the PRINT/SCAN key.
To Next Page
Loading...
Need help?
General
