Waveform Display Function
Copyright © Itech Electronic Co., Ltd. 50
2. Press the right soft key corresponding to the parameter to select the
required trigger configuration.
⚫ Source: Select the trigger source, voltage signal, current signal or
DVM signal.
⚫ Mode: Select the trigger mode: Auto or Norm.
⚫ Slope: Select trigger slope: rising edge (↑), descending edge (↓) or
either edge (↑↓).
⚫ Single: Single measurement key: when single measurement is
performed under stop conditions, the stop status will be enabled again
after one measurement according to the current data updating rate.
When single measurement is performed under running conditions, one
measurement will be performed immediately by the instrument and
then the stop status will be enabled.
To Next Page
Loading...
Need help?
General
