To Next Page

To Previous Page

List Function

Chapter7 List Function

This chapter describes the features and use of the List function of the IT6400

series power supply in details.

7.1 Basic Concepts

The User can edit the test procedures composed of several steps through the

List function. There are 20 Lists (List 0 to List 19) under the List function for

selection, which can be controlled through the Select parameters on the

interface. Values are as follows:

⚫ Y: this List is selected and executable.

⚫ N: this List is neither selected nor executable.

The User can flexibly select the List to form different sequence output. A

maximum of 30 steps (Point 0 to Point 29) can be configured in each List. The

User can edit the voltage, current, resistance and step time. Relationship

between List and Sequence is shown below.

Introduction of List interface

⚫ IT6411/IT6431/IT6432/IT6433/IT6411S/IT6432S

ITech IT6400 Series User Manual

Other manuals for ITech IT6400 Series