ITech IT6400 Series - Page 97

Technical Specification
Copyright © Itech Electronic Co., Ltd. 89
（％of Output +Offset）
Input Common-mode
voltage
< 100Vdc to ground
Common-mode voltage
rejection
≥ 80 dB
Input impedance
4.5MΩ
(*1) Maximum error of OVP precision at power supply terminal under full load.
(*2) Under Fast mode, the output polarity is unchanged, the time that the power
output value changes from 10% to 90%.
(*3) The Minimum value of CC setting is 2mA.
(*4) The voltage setting value will change to 0V under power supply output is
30V.
(*5) The current readback accuracy of the 20mA Range is measured under
constant voltage mode.
(*6) Set output off.
Parameters
IT6432S
Rated values
(0 °C-40 °C)
Voltage
-30V-0V,0-30V
Current
±21m A
Power
0.63 W
Resistance
0-20 Ω
Load regulation
(％of Output+Offset)
Voltage
≤0.01%+1mV
Current
≤0.05%+0.05mA
Line regulation
(％of Output+Offset)
Voltage
≤0.02%+1mV
Current
≤0.05%+0.05mA
Setup resolution
Voltage
1mV
Current
10uA
OVP
1 mV
Resistance
10mΩ
Readback resolution
Voltage
1mV
Current
21mA Range
1uA
100uA Range
1nA
Setup accuracy
（one year、25°C±5°C)
(％of Output+Offset)
Voltage
≤0.02%+3mV
Current
≤0.05%+10uA
OVP
0.5V ¹
Resistance
≤0.1%+50mΩ
Readback accuracy
（one year、25°C±5°C)
(％of Output+Offset)
Voltage
≤0.02%+2mV
21mA Range
≤0.05%+10uA
100uA Range
≤0.05%+50nA
4
Ripple
(20Hz -20MHz)
Voltage
1.5kR Load ≤ 3mVp-p / 0.6 mV rms
Current
200R Load ≤1uArms
Setup Temp.coefficient
(％of Output+Offset)/℃
Voltage
0.01%+0.2mV
Current
0.01%+2uA
OVP
0.1%+50mV