ITech IT7321 - Status:questionable:enable<Enable Value; Status:questionable:ntransition

System Commands
Copyright © Itech Electronic Co., Ltd. 15
Query syntax
STATus:QUEStionable:CONDition?
Parameters
None
Returns
<NR1>
STATus:QUEStionable:ENABle<Enable value>
This command edits the enable register value of query event. In query, the
power supply will return a decimal number representing the binary weighted
sum of the enable register.
Command syntax
STATus:QUEStionable:ENABle <NRf>
Parameters
0~65535
Power on value
Refer to *PSC command.
Example
STATus:QUEStionable:ENABle 16
Query syntax
STATus:QUEStionable:ENABle?
Returns
<NR1>
Related commands
*PSC
STATus:QUEStionable:NTRansition
This command set the value of the Questionable NTR (Negative-Transition)
register. The register serve as polarity filters between the Questionable
Condition and Questionable Event registers to cause the following actions.
When a bit of Questionable NTR register is set to 1, then a 1-to-0 transition of
the corresponding bit of the Questionable Condition register causes that bit in
the Questionable Event register to be set.