ITech IT7321 - Chapter15 IEEE488.2 Common Commands; Cls; Ese

IEEE488.2 Common Commands
Copyright © Itech Electronic Co., Ltd. 55
Chapter15 IEEE488.2 Common Commands
*CLS
This command clears the following registers:
⚫ Standard event register
⚫ Query event register
⚫ Status byte register
Command syntax
*CLS
Arguments
None
*ESE
This command can set the parameter of standard event enable register.
Setting parameter can determine which bit of standard event register is 1
and the byte will enable ESB of status byte register is 1.
Command syntax
*ESE <NR1>
Parameters
0~255
Power on value
Refer to *PSC command
Example
*ESE 128
Query syntax
*ESE?
Returns
<NR1>
Related commands
*ESR? *PSC *STB?