ITech IT7321 - LAN and GPIB Interfaces

Maximum Power Point Scanning Commands
Copyright © Itech Electronic Co., Ltd. 47
Example
SWEep:STARt:VOLTage 100
Query syntax
SWEep:STARt:VOLTage?
SWEep:STEP:VOLTage
This command is used to set the voltage step of the sweep.
Command syntax
SWEep:STEP:VOLTage <NR1>
Parameters
MINimum|MAXimum|Float
Example
SWEep:STEP:VOLTage 1
Query syntax
SWEep:STEP:VOLTage?
SWEep:END:VOLTage
This command is used to set the termination voltage of the scan function.
Command syntax
SWEep:END:VOLTage <NR 1>
Parameters
MINimum|MAXimum|Float
Example
SWEep:END:VOLTage 5
Query syntax
SWEep:END:VOLTage?
SWEep:STEP:TIMe:UNIT
This command is used to set the single-step time unit of the scan function.
Command syntax
SWEep:STEP:TIMe:UNIT <NR1>