ITech IT7321 - List:step:dwell:unit; List:step:dwell

List Operation Commands
Copyright © Itech Electronic Co., Ltd. 41
Parameters
Number of steps, 0 ~ 99
LIST:STEP:DWELl:UNIT
This command is used to set LIST single-shot delay time unit. Parameters 1
and 2 are mandatory.
Command syntax
LIST:STEP:DWELl:UNIT
Parameters
Number of steps, 0 ~ 99
Parameter 2
Time unit, SECond|MINUte|HOUR
Example
LIST:STEP:DWEL:UNIT 2,SEC
Query syntax
LIST:STEP:DWELl:UNIT?
Parameters
Number of steps, 0 ~ 99
LIST:STEP:DWELl
This command is used to set LIST single-step delay time. Parameters 1 and 2
are mandatory.
Command syntax
LIST:STEP:DWELl
Parameter 1
Number of steps, 0 ~ 99
Parameter 2
Time value, Float
Example
LIST:STEP:DWEL 3,20
Query syntax
LIST:STEP:DWELl?