IEEE488.2 Common Commands
Copyright © Itech Electronic Co., Ltd. 57
Query syntax
*OPC?
Returns
None
*RST
This command is used to reset the power to factory default setting.
Command syntax
*RST
Parameters
None
*SRE<Enable value>
This command sets the condition of the Status Request Enable Register.After
executing this command, AC power supply will return back a decimal value
which is a binary weighted sum of all bits from the enable register.
Command syntax
*SRE <NRf>
Parameters
0~255
Power on value
Refer to *PSC command
Example
*SRE 128
Query syntax
*SRE?
Returns
<NR1>
Related commands
*ESE *ESR? *PSC *STB?
*STB?
This command can read the data from status byte register. After execute this
To Next Page
Loading...
