ITech IT7321 - Chapter6 Voltage Control Commands; [Source:]Voltage[:Level][:Immediate][:Amplitude]; [Source:]Range

Voltage Control Commands
Copyright © Itech Electronic Co., Ltd. 27
Chapter6 Voltage Control Commands
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
This command is used to set the output voltage of the power supply.
Command syntax
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
Parameters
MINimum|MAXimum|DEFault|Float
Example
volt:imm 100
Query syntax
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]?
[SOURce:]RANGe
This command is used to set the voltage and current range.
Command syntax
[SOURce:]RANGe
Parameters
AUTO|HIGH
Example
rang auto
Query syntax
[SOURce:]RANGe?