ITech IT7321 - List:repeat; List:step:voltage

List Operation Commands
Copyright © Itech Electronic Co., Ltd. 39
Query syntax
LIST:STEP:COUNt?
LIST:REPeat
This command is used to set the running times of list file.
Command syntax
LIST:REPeat
Parameters
1~10000
Example
LIST:REP 100
Query syntax
LIST:REPeat?
LIST:STEP:VOLTage
This command is used to set LIST single-step voltage.
Command syntax
LIST:STEP:VOLTage
Parameter 1
Number of steps, 0 ~ 99
Parameter 2
Voltage, Float, Unit: V
Example
LIST:STEP:VOLT 1,30
Query syntax
LIST:STEP:VOLTage?
Parameters
Number of steps, 0 ~ 99
Example
LIST:STEP:VOLT? 1