To Next Page

To Previous Page

Calibration Commands

Parameters

P1|P2

CALibrate:POWer [:DATa] {<numeric value>}

This command returns the actual output power value of the current calibration

point of the power supply.

Command syntax

CALibrate:POWer [:DATa] <NRf>

Parameters

<NRf>

Example

CAL:POW 80W

CALibrate:STRing

This command is used to set the calibration information during calibration.

Command syntax

CALibrate:STRing <Parameters>

Parameters

Support inputting a maximum length of 24 letters of string, which is recorded

the user calibration information. Such as the calibration time, frequency and so

on.

Example

CAL:STR "2005-1-9 20:12"

CALibrate:STRing?

This command is used to check the current calibration information.

Query syntax

CALibrate:STRing?

Returns

Calibration information saved in the power supply.

ITech IT7321 Programming Guide

Other manuals for ITech IT7321