TRACe Subsystem Commands
Copyright © Itech Electronic Co., Ltd. 33
Returns
{<NR3>}
The following is an example of how to use the commands of the Trace
subsystem:
1. TRACe:FREE?
This command is executed to confirm the current buffer status.
2. TRACe:POINts
This command is executed to set the size of the buffer.
3. TRACe:FEED
This command is executed to set the type of reading source saved to the
buffer, such as VOLTage.
4. TRACe:FEED:CONTrol
This command is executed to set the save mode of the buffer, such as
NEXT.
5. TRIGger[:IMMediate]
This command is executed to trigger the IT7300 instrument to enter data
storage status.
6. TRACe:DATA?
This command is executed to read the data stored in the buffer to the PC
interface.
To Next Page
Loading...
