ITech IT8900 Series

To Next Page

To Previous Page

Function and Features

Run Recall Edit

2. Operate key and move to Edit. Press [Enter] key to enter

editing test files.

EDIT PROGRAM

Active Sequence=0987654321

3. Press numeric key to select test step and press [Enter] key. Active

Sequence= 09876543YY (indicating that 1/2 step has been selected).

EDIT PROGRAM

Active Sequence=09876543YY

4. Select whether pause is necessary for these two steps. If step 2 is to be

paused, press 2 key. If not, directly press [Enter] key.

EDIT PROGRAM

Pause Sequence=□□□□□□□□Y1

5. Select whether short-circuit test is necessary for these two steps. If step 1

is to be tested, press 1 key. If not, directly press [Enter] key.

EDIT PROGRAM

Short Sequence=□□□□□□□□2Y

6. Set loading time of step 1. If 2S is required, directly press 2 key on the

board. Press [Enter] key.

EDIT PROGRAM

SEQ01 On Time=2S

7. Set unloading time of step 1. If 2S is required, directly press 2 key. Press

[Enter] key.

EDIT PROGRAM

SEQ01 Off Time=2S

8. Set test delay time of step 1. If 1S is required, directly press 1 key. Press

[Enter] key. Tpf is delay time before measurement.

EDIT PROGRAM

SEQ01 P/F Delay Time=1S

9. Set loading time of step 2. If 2S is required, directly press 2 key. Press

[Enter] key.

EDIT PROGRAM

SEQ02 On Time=2S

10. Set unloading time of step 2. If 2S is required, directly press 2 key. Press

[Enter] key.

EDIT PROGRAM

SEQ02 Off Time=2S

11. Set test delay time of step 2. If 1S is required, directly press 1 key. Press

[Enter] key. Tpf is delay time before measurement.

EDIT PROGRAM

SEQ02 P/F Delay Time=1S

ITech IT8900 Series - Page 58