FC300 Getting Started Guide 7
Proprietary and Confidential
System Status LED
The System Status LED indicates power management status.
Blinking red Battery power failure; critical suspend.
Solid red Main battery is low.
Blinking green FC300 is in System Idle. The display is turned
off, but the FC300 is still powered on. For
details, see Setting Power Schemes on page
37.
Yellow/amber Initial few seconds when Power key is
pressed.
off None of the above.
Setting Up a New FC300
There are several hardware and software setup tasks to complete prior
to using a new FC300. Use the following checklists to perform the
task, in the order provided.
Hardware Setup Checklist
1 Connect or apply
optional accessories.
• Attaching the Antenna on page 49
(optional).
• Applying the Touch Screen
Protective Film on page 68
(optional).
2 Connect cables. External Power Supply on page 10.
3 Insert the battery. Installing the Battery on page 9.
4 Charge the battery. Charging the Battery on page 9.
5 Power on the FC300. Power on/suspend/off the FC300 on
page 12.
To Next Page
Loading...
Need help?
General