12 FC300 Getting Started Guide
Proprietary and Confidential
Applying External Power to the FC300
Before beginning, review the setup for the AC power unit (see
External Power Supply on page 10) and the features of the USB
client Y cable on page 11.
To apply external power to the FC300
1. Using the USB client Y cable, pinch the catch/release latches on
the I/O connector until they are open.
2. Connect the I/O connector to the bottom of the FC300, matching
the shape of the connectors.
3. Release the catch/release latches.
4. Insert the single-pin cable end of the AC power unit into the
single-pin AC adapter from the USB client Y cable.
5. Plug the AC power unit into a wall outlet power source.
6. Insert the USB type A plug from the USB client Y cable into the
USB host port on the PC.
Power On/Suspend/Off the FC300
The FC300 has three power modes.
• On. The keyboard, touch screen, and all peripherals function
normally. The touch screen backlight is on until the User Idle
timer expires. The touch screen does not turn off until the
System Idle timer expires. For information about the idle timers,
see Setting Power Schemes on page 37. The FC300 remains in
the On state as long as any of the following activity occurs:
• Pressing any key on the keypad, except Power.
• Tapping the touch screen.
• Incoming data through the scanner port.
To Next Page
Loading...
Need help?
General