68 FC300 Getting Started Guide
Proprietary and Confidential
To provide power to the FC300
1. Using the FC300 charger cable, plug the (1) end into the I/O
(input/output) connector on the bottom of the FC300.
2. Plug the (2) end into the vehicle's 12 volt DC power supply
receptacle (cigarette lighter).
Applying the Touch Screen Protective Film
(Optional) Apply the touch screen protective film to extend the life of
the touch screen.
To apply the touch screen protective film
1. Clean the touch screen from fingerprints, lint particles, dust, and
smudges. See Cleaning on page 69.
2. Remove the protective film from its container
3. Remove the protective backing from the film sheet by lifting the
backing from a corner of the film. Discard the backing.
4. Apply the film to the touch screen starting at one side and
smoothing it across the display area until it covers the glass
surface of the display.
• If air bubbles appear, raise the film slightly and continue
smoothing the film across the display area.
• If dust, lint, or smudges are trapped between the protective
film and the glass display, remove the film, clean the display
area, and apply the film again.
To Next Page
Loading...
Need help?
General