Apply antifouling Gummipaint A/F 6435
(.153 white, or .714 grey, or .708 black).
• Degrease the SAU surface to be treated with an
appropriate solvent or detergent (e.g. Detersil™);
if necessary, sand down using abrasive paper
P150-180 (or G150), apply primer on all the
surface then blow with fresh and dry air.
• Mix the antifouling for a few minutes to have a
complete homogeneity.
• Apply the antifouling (4 coats recommended, at
least 8h. overcoating interval) by:
> Brush. Dilute it with Thinner 6380 up to 5-10%
in volume. Brush it by making horizontal
strokes with a uniform and constant thickness.
> Spray. Dilute it with Thinner 6380 between 20-
30% in volume. Spray it.
Wait at least 24 hours before launching the SAU.
To Next Page
Loading...
