4 CONTROLS
en-23
4.2.8 DPF SWITCH _____________________________________________________________
With the switch in the center position (default) it allows automatic Active Regen. Operation of
the mower is not changed during Active Regen. See 8.15
When the Regen Request light flashes, press and release the front part of the switch to start
the Parked Regen cycle.
To prevent damage to the turf during Parked Regen, park the mower on concrete or gravel. The
engine must be warm (above 65° C / 149° F), the traction pedal in NEUTRAL position, mow
switch in OFF position, the parking brake engaged and the throttle in idle position for the
Parked Regen cycle to start.
Do not stop the engine, disengage the parking brake or drive the mower until the Regen cycle
is completed and the Regen Request light turns off. See 8.15
4.2.9 HIGH SPEED SWITCH______________________________________________________
Used to switch the mower between the high and low speeds. Always mow with the switch in the
SLOW speed position.
Push the front of the rocker switch to operate the mower in the high speed.
Push the rear of the rocker switch to operate the mower in the slow speed.
4.2.10 LIGHT SWITCH (OPTIONAL)________________________________________________
Allows manual operation of the road lights.
Position 1. OFF
Position 2. Side / Marker Lights
Position 3. Dipped Beam.
Note, Position 3 needs the ignition in the ON position.
4.2.11 HAZARD WARNING SWITCH (OPTIONAL) ____________________________________
Turns the four indicator lamps ON.
Push the front of the switch to turn ON.
Push the rear of the switch to turn OFF.
When the switch is turned on, the red lens flashes.
To Next Page
Loading...
Need help?
General
