JANDS – Event 4 Version 5 Users Manual
Page 62 Revision 5.0.0.5 25/11/02
Move the Cursor to the Confirm field and Press the + (On) button to confirm the
changes.
Fader channels numbered higher than the number of physical faders must be
controlled using the Fader (Next), And, At and Thru buttons combined with the
numeric keypad. Refer to section 8.2 for details
Virtual Faders default to being scaled by the P1 master. However they can be set to
being scaled by the P2, P1 and P2, or Hold master
17.1.3 The Setup Desk Link Submenu - Connecting a Slave Console
A second console (Jands Event 4, Event, ESP II or Stage 12/24) can be connected to
provide extra Preset faders. The master controls on the slave console are disabled.
To do this the main console must be set to Master operation and the other console
must be set to Slave operation. Press Setup and open the Desk submenu and open
the Link submenu to set the mode.
Set Master Slave
Link Off Off
17.1.4 Setup Desk Link Master - Turning Master Mode On
Master Move the cursor to this field and press the + (On) button to set the
console as a Master. A confirm screen follows. Move the cursor to the
Confirm field and press the + (On) button to confirm the change.
17.1.5 Setup Desk Link Master - Turning Slave mode on
Slave Move the cursor to this field and press the + (On) button to set the
console as a Slave. A confirm screen follows. Move the cursor to the
Confirm field and press the + (On) button to confirm the change.
Press the Exit button to cancel Slave operation.
NOTE: The mimic LEDs do not function when in slave mode.
To Next Page
Loading...
Need help?
General
