Software Version 5.0
25/11/02 Draft Page 11
2 Resetting the Console
Reset is used to perform a clean start, revert all settings to the factory defaults and
clear all data including Memories, Chases, and Patches. Reset can be used to quickly
erase all data that has been recorded in an Event.
NOTE: It is recommended that a Reset be performed each time a new show is to
be recorded.
2.1 To Reset the Console
First turn urn the power switch off and then follow the steps below to reset the
console:
Hold the DBO, ADD/SOLO, P1/2 and Sample buttons (the 4 buttons located above
the Master faders) down while turning power on to the console.
Press the Record button to confirm the console Reset.
2.2 To Load a New Software Version
Software updates are released from time to time and are available from Jands dealers
or by download from the Jands website – www.jands.com.au. If the software is
downloaded it must be unzipped onto a floppy diskette in the directory a:\bootrom
To load new software, insert the software update disk into the disk drive. Then:
Hold the Record button down while turning power on to the console.
In the Programmer press the button labelled Load Flash.
When the confirm screen appears. Press the button marked Yes to confirm the update.
The console will restart automatically when the update is complete.
Note: All show data will be erased from the console during this procedure
To Next Page
Loading...
Need help?
General
