Software Version 5.0
25/11/02 Draft Page 33
5. Press and hold the Record button, and press the palette button that the beam
is to be recorded into.
That beam will be recorded into all fixtures of the type selected.
If more than one fixture of a type is selected and the beam setting for these two
fixtures are different, then the beam setting for the lowest number fixture is used as the
common setting for all other non-selected fixtures. The beam setting for the 2
nd
(higher
number) fixture is regarded as a unique setting for that light alone.
If a different fixture needs to be included in a palette at a later stage, it is possible to
re-record the palette. It will not affect the previously recorded values.
If a fixture is patched at a later stage and the same type of fixture has beam
information in a palette, this new fixture is added to the palette automatically.
9.5 Recording Group Palettes
Group palettes can include Fixtures and / or Scrollers.
To record a Group palette:
1. Press the Fixture button.
2. Select the required Fixtures
And / or
3. Press the Scroller button.
4. Select the required Scrollers
5. Press the Group button.
6. Press and hold the Record button, and press the palette button that the
positions are to be recorded into.
To Next Page
Loading...
Need help?
General
