Jands Event 4 User Manual

JANDS – Event 4 Version 5 Users Manual
Page 72 Revision 5.0.0.5 25/11/02
highest numbered Fixture is selected and its intensity is set to the Next Intensity
setting (default - 100%). These settings can be changed as follows
Prevint Sets the Intensity of selected Fixtures that are not highlighted.
(0 – 100%)
Nextint Sets the Intensity of the currently selected Fixture. (0 – 100%)
17.6.6 Setup Prefs PTimes – Setting Live Palette Fade Time
When the Palette buttons are used live it is possible to set a fade time so that any
changes fade in rather than snap. Changes made here apply to all Palettes but only
when the palette is set, in the Programmer LCD, to use time.
Set PrevInt NextInt Ptime
Prefs 15 100 0:01.0
PTime The default setting is 1 second. Can be set from 0.01s 9M 59.9s
17.7 The Setup Backup Submenu
Press Setup and open the Bkup submenu to save and restore show data to and from
the disk drive. Backup is detailed in Section 6

Jands Event 4 Specifications

General

Brand	Jands
Model	Event 4
Category	Lighting Equipment
Language	English