Software Version 5.0
25/11/02 Draft Page 75
19 Service & Maintenance
With care the Event 4 console will require little or no maintenance. However, the
internal battery will need to be replaced on a regular basis (see the following section).
If the front panel requires cleaning, wipe with a mild detergent on a damp soft cloth.
The diskette drive mechanism is mechanical and should always be treated with care.
Never allow the entry of fluids into the slot, and always ensure a diskette is in the
drive when the console is moved.
DO NOT spray liquids onto the front panel.
DO NOT use solvents for cleaning the front panel.
Warning
Do not allow the entry of liquids of any sort into the console chassis
20 Battery Replacement
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
The internal battery within the Event 4 should be replaced every 3 years or whenever
problems are experienced with the console in terms of losing memories.
The battery should only be replaced by experienced service personnel.
To replace the battery, follow the procedure listed below:
1. Remove base of console.
2. Desolder battery on CPU card, taking note of connection polarity.
3. Install new battery and solder into place.
4. Install base of console.
WARNING
Replacing the battery will cause the console to lose all stored data. Save ALL critical
information to a floppy diskette prior to replacement.
NOTE:
Contact your authorised Jands Distributor for repairs or servicing.
In Australia refer all repairs to an authorised Jands service agent or return the faulty
unit in suitable packaging to:
JANDS Pty Limited Service Department.
40 Kent Rd, Mascot, NSW 2020, Australia.
Phone: +61 2 9582-0909, Fax: +61 2 9582-0999
To Next Page
Loading...
Need help?
General
