EasyManuals Logo

Jands Event 4 User Manual

Default Icon
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
JANDS – Event 4 Version 5 Users Manual
Page 58 Revision 5.0.0.5 25/11/02
16.1.3 To Change the Operation of the Chase Flash Button
1. Press the Setup button to open the Setup Menu.
2. Move the cursor to the Ctrl (Controls) field and press the + (On) button to
open the Set Control menu.
3. Move the cursor to the CHS field and press the + (On) button to toggle
between Norm (Normal) and Sngl (Single).
4. Press Exit to close this menu.
16.2 Controlling Stacks
To control a Stack you use either a single or two adjacent Assign Masters. To get the
Stack onto these Masters you can use two different Methods. The best Method to use
will depend on the type of show that you are running, as explained below:
16.2.1 Method 1: Using the Assign Stack Menu
This Method is best if you are only using a Stack occasionally or for a specific part of
a show.
1. Press Assign then Stack to open the Assign Stack menu
2. Set the first memory or chase to playback.
3. Press an Assign master flash button to put the Stack on that fader
16.2.2 Method 2: Using the Stack Menu
If you want to have a Stack available all the time it is best to use the Stack menu to
dedicate a fader (or fader pair) to Stack playback.
Press Stack button to display the menu
Type First Assign Load Mask
Std M 10.00 1 Off Off
Type This field can be set to either Std, MTC or Prog.
Std is the default setting and most commonly used.
MTC is for playback using Midi Time Code.
Prog is for playback using Midi Programme messages.
First Sets the first memory (or Chase) number.
Assign Sets the Assign Fader/s used to control the stack playback.
Mask Sets any or all of Intensity, Focus, Colour and Beam to be masked during
playback. Masked parameters are recorded but ignored during playback.
Any letter (IFCB) shown indicates that the parameter will be masked. eg.
if the display shows I-BF only the colour information will play back. All
other parameters will remain under the previous control.
Load Turns the Stack On or Off. When this field is changed to On (or Off), the
menu is automatically closed.

Table of Contents

Other manuals for Jands Event 4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jands Event 4 and is the answer not in the manual?

Jands Event 4 Specifications

General IconGeneral
BrandJands
ModelEvent 4
CategoryLighting Equipment
LanguageEnglish

Related product manuals