Jands Event 4 User Manual

JANDS – Event 4 Version 5 Users Manual
Page 32 Revision 5.0.0.5 25/11/02
If a different fixture needs to be included in a palette at a later stage, it is possible to
re-record the palette. It will not affect the previously recorded values.
If a fixture is patched at a later stage and the same type of fixture has colour
information in a palette, this new fixture is added to the palette automatically.
9.3 Recording Scroller Colour Palettes
When recording scroller colour palettes, only one scroller needs to be selected prior to
the Record button being pressed. Unselected scrollers will also be recorded. In this
way only one scroller needs to be adjusted to record that colour for all scrollers.
Eg. to record a scroller colour palette:
1. Press the Scroller button.
2. Select the first scroller.
3. Press the Colour button.
4. Use the wheels to change the colour of this scroller.
5. Press and hold the Record button, and press the palette button that the colour
is to be recorded into.
That colour will be recorded into all scrollers.
If more than one scroller is selected, and the colour settings for those are different,
then the colour setting for the lowest number scroller is used as the common setting
for all other non-selected scrollers. The colour setting for the 2
nd
(higher number)
scroller is regarded as a unique setting for that scroller alone.
If a scroller is patched at a later stage, this new scroller is added to the recorded
palettes automatically.
9.4 Recording Beam Palettes
When recording Beam palettes, only one fixture of each type needs to be selected and
adjusted to record that beam. Unselected fixtures of the same type are automatically
included when the palette is recorded. However if individual settings for each light are
required then some, or all, fixtures can be selected and a unique beam will be recorded
for each selected fixture.
Additionally only the beam parameters that have changed are recorded. The LCD
displays UnMa (UnMask) for the beam parameters that have been changed. A beam
parameter that has been adjusted and Unmasked can be excluded from a palette by
pressing the corresponding UnMa/Mask switch. As an example, this allows different
gobo settings in palettes 1-10, different strobe rates in palettes 11-15, and different iris
settings to be recorded in palettes 15-20. Because multiple beam palettes can be
played back at one time, settings for gobo, strobe, and iris can be combined.
To record a fixture beam palette:
1. Press the Fixture button.
2. Select the first fixture.
3. Press the Beam button.
4. Use the wheels to change only the beam parameters that are to be recorded for
this fixture.

Jands Event 4 Specifications

General

Brand	Jands
Model	Event 4
Category	Lighting Equipment
Language	English