Page 42
ENGLISH
Jandy
®
, JXi
™
Gas-Fired Pool & Spa Heater
|
Installation & Operation Manual
11.3 Ignition Control LED Service Codes
In addition to service diagnostic messages, the ignition controller has an LED light that ashes to indicate various
ignition control faults. The table below lists the LED codes and the corresponding fault description. To diagnose
possible cause and remedy, refer to Section 10.2, Service Diagnostic Messages.
LED Code Fault Description
The LED light is on
continuously.
Ignition Control Fault. Refer to
qualified service personnel.
LED single flash. Air flow fault.
LED double flash. Flame exists when there is
NO call for heat. Refer to
qualified service personnel.
LED triple flash. Ignition lockout (heater has
made three (3) unsuccessful
attempts to fire and is in a soft
lockout condition).
Section 12. Professional Service and Maintenance
Call a qualied service technician to perform all service and repairs on the heater. To locate a licensed or qualied
technician or independent service company in your area, contact Zodiac Technical Support at:
1-800-822-7933
www.jandy.com
Before servicing the heater:
• Conrm that the heater control is set to either POOL or SPA
• Conrm the temperature set point for either Pool or Spa is set high enough to make the heater operate given the
current water temperature.
WARNING
SERVICING SAFETY
Service procedures can be hazardous because they involve fuel
gas, electricity, moving parts and procedures which require testing
or temporary bypass of safety controls. For this reason, the heater
mustbeservicedonlybyaqualiedprofessionalservicetechnician.
IMPROPER SERVICE HAZARD
The heater incorporates unique design features. Incorrect service
of this heater can result in personal injury or damage to property. To
avoidsuchhazards,theheatermustbeservicedonlybyaqualied
professional service technician.
Section 13. Spare Parts
Using genuine Zodiac factory replacement parts helps to ensure the ongoing quality and reliability of our products.
Unauthentic parts might seem okay on the surface, but they often fall short of factory standards, and they typically
lack the backing you get from an established, global manufacturer like Zodiac. Plus, the use of unauthentic parts voids
all factory warranties.
Zodiac does not sell parts directly to pool owners, so when it’s time for maintenance, please see your local Preferred
Professional Provider (PPP) of genuine parts. You can nd a PPP at www.zodiacpoolsystems.com/parts.
NOTE: To identify the correct part, you will need to know the
model number, serial number and type of gas when applicable. This
information can be found on the rating plate sticker, which is located
inside the heater on the outside of the combustion chamber.
To Next Page
Loading...
Need help?
General
