Janome Skyline S9 - Placement Guides of Designs for Fabric

143
b Sew the third section (color) over the design. The
buttery wings are attached to the background fabric.
Sew the rest of the section (color) and remove the
tape to complete the design.
Placement guides of “Designs for fabric”
Each embroidery design in Designs for fabric category contains a placement guide section for placing designs for
water soluble stabilizer.
After the placement guide is sewn, the machine will sew over the lace piece with the next section (color) to hold the
piece.
The placement guides and their sewn orders are indicated below. Place the desired lace piece on the placement
guide and hold it with tape. Sew over the lace piece with the next section to hold the piece.
FA10a-1
2nd section
FA10a-2
4th section
FA10a-3
2nd section
FA10a-4
2nd section
FA10a-5
3rd section
FA10a-6
1st section
FA10a-7
1st section
SQ14a-1
2nd section
SQ14a-2
2nd section
SQ14a-3
3rd section
SQ14a-5
4th and 6th sections
RE20a-1
5th, 6th, 7th 8th and 9th sections
NOTE:
The other buttery design also
requires a combination of the water
soluble stabilizer design FA10a-2 and
the fabric design FA10a-2. Place the
buttery wing piece on the placement
guide and continue sewing.