105
Language Selection Mode
Select the desired language and press the OK key.
The visual touch screen shows messages in the selected
language.
Correcting Distorted Stitch Patterns
The sewing results of the stitch patterns may vary
depending upon sewing conditions, such as sewing
speed, type of the fabric, number of layers etc.
Always test sew on a scrap piece of the fabric that you
wish to use.
If decorative stitch patterns, monogram or the stretch
buttonhole is distorted, correct it with the feed balancing
dial.
Remove the cap by using the screwdriver etc. Make sure
not to scratch the machine body with the screwdriver.
Set the feed balancing dial at the neutral position for
normal sewing.
q Cap
w Feed balancing dial
e Neutral position
Stretch stitch pattern (Q18)
If the pattern is compressed, turn the feed balancing dial
in the direction of “+”.
If the pattern is drawn out, turn the feed balancing dial in
the direction of “–”.
Letters and numbers
If the pattern is compressed, turn the feed balancing dial
in the direction of “+”.
If the pattern is drawn out, turn the feed balancing dial in
the direction of “–”.
Stitch balance of the stretch buttonholes (B8)
If the right row is denser, turn the dial in the direction of “+”.
If the left row is denser, turn the dial in the direction of “–”.
NOTE:
Return the feed balancing dial to its neutral position
when the sewing is nished.
+ –
+ –
+ –
w
e
q
To Next Page
Loading...
