144
Lace Design RE20a-1 (Designs for water soluble
stabilizer)
You can attach up to 4 ower designs to the large lace
design (Designs for water soluble stabilizer) RE20a-1.
z Prepare the ower designs you want to attach before
sewing the lace design RE20a-1. Select the desired
ower designs from the “Designs for water soluble
stabilizer” category, and sew them to the water soluble
stabilizer. Remove the water stabilizer by soaking the
ower designs into a bowl of warm water.
x Draw centerlines on the water soluble stabilizer with
tailor’s chalk. Set the water soluble stabilizer in the
hoop RE20a and attach the hoop to the carriage.
Select the RE20a-1 design (Designs for water soluble
stabilizer).
c Sew until the 11th section (color). The 11th section is
the placement guide for placing ower designs.
Place one of the ower design pieces which was
created in procedure z above so that the ower
design is aligned with the placement guide.
x
z
c
v v Use tape to hold the design for your convenience.
Sew the 12th section (color) over the design. The
ower design is attached to the large lace RE20a-1
design.
b Sew the rest of the sections. The 13th, 15th and 17th
sections are the placement guides. Place the ower
designs created in procedure z and sew over ower
designs (same as done in procedure v).
Remove the design from the hoop.
Remove the water stabilizer by soaking the overall
design into a bowl of warm water to complete the
design.
b
To Next Page
Loading...
