16
x
Threading the Machine
CAUTION:
Always make sure to press the lockout key to lockout
the machine before threading the machine.
e
r
y
t
u
i
o
c
v
b n m
Press the needle up/down button to raise the take-up
lever to the highest position.
Press the lockout key to lockout the machine. The
presser foot will go down and the upper thread tension
disks will open.
q Lockout key
Pass the thread in order z to m.
z Hold the thread with both hands and pass the thread
into the guide slot.
w Guide slot
x Hold the thread with both hands and draw the thread
around the corner of the guide.
Firmly pull the thread toward you along the right
channel until the thread snaps.
e Corner of the guide
r Right channel
c Draw the thread down along the right channel and
around the bottom of the thread guide plate. Pull the
thread up along the left channel.
r Right channel
t Thread guide plate
y Left channel
v While holding the thread at the spool, rmly draw the
thread up and to the back of the take-up lever. Draw
the thread forward to draw it into the eye of the take-
up lever.
u Eye of the take-up lever
b Then pull the thread down along the left channel and
through the lower thread guide.
i Lower thread guide
n Slide the thread from the right of the needle bar thread
guide to the left.
o Needle bar thread guide
m Thread the needle with the needle threader (refer to
the next page).
z
xv
c
b
n
m
w
z
r
q
To Next Page
Loading...
