45
n
m
,
m After you nish buttonhole sewing, push the
buttonhole lever up as far as it will go.
, Place a pin just below the bartack at each end to
prevent accidentally cutting the threads. Cut the
opening with the seam ripper. Use an eyelet puncher
to open a keyhole buttonhole.
n The buttonhole is sewn automatically in the sequence
shown. When the buttonhole is nished, the machine
will stop automatically with the needle in the up
position. Press the thread cutter button and remove
the fabric.
Double layer buttonhole
To make a sturdy buttonhole, sew another layer of
buttonhole stitches over the previous stitches.
After the buttonhole is nished, simply start the machine
again.
Do not raise the foot or buttonhole lever.
Do not reselect the pattern.
NOTE:
This function is disabled if Thread Cut after Auto-
Lock option is turned on in the ordinary sewing setting
mode (refer to page 101).
To Next Page
Loading...
