- 102 - Orion - 324501H
FR
DEEN
8.2-
Choice of operating radio frequency
To ensure good operating quality, it is important that the radio channel used
be free throughout the area in which the machine will be controlled.
If several radio remote controls are operating on the same site, frequencies
spaced by at least two radio channels (for example: 5, 7, 9 ...) should be
used and, if necessary, a frequency plan should be drawn up, specifying
the various machines controlled and their working frequency.
8.3-
«Continuous NC or NO» relay operating mode
If a system is used in continuous mode with the control buttons maintained
pressed and the operator moving about, transmission interruptions can
occur due to the dispersion and propagation of radiowaves which must be
taken into account in accordance with the application.
8.4-
Minimum and maximum current of relay outputs
Be sure not to exceed the minimum and maximum characteristics specifi ed
in chapter Technical characteristics, by installing, if necessary, an
additional load or intermediate relays (auxiliary contacts in electrical
cabinet for power control, for example).
8.5-
«Multifunction» transmitters equipped with
accumulators and charger support (ORCL•)
When transmitters are equipped with accumulators, please charge them for
approximately 3 hours before a fi rst use.
DRAFT a
To Next Page
Loading...
Need help?
General
