- 82 - Orion - 324501H
FR
DEEN
7.4-
«Customized» Transmitter / Receiver association
Once transmitter identity code was chosen and programmed, receiver
relays must be associated to transmitter buttons. Transmitter and
receiver have to be on the same operating radio channel.
IMPORTANT :
each receiver relay can learn a maximum of :
ORRS and ORRD receivers : 10 different «button numbers
+ identity codes»
ORRA receivers : 4 different «button numbers + identity
codes»
In case of association programming error, the receiver
memory can be erased by following the procedure
described in chapter Receiver parameter erasing
procedure.
1
ORRS and ORRA receivers : Switch off the receiver
ORRD receiver : the receiver can remain powered up throughout the procedure
2
ORRS and ORRA receivers : install the jumper to confi gure the settings.
ORRD receiver : set the microswitch
to the «ON» position
R2
R3
R4
V1 V2 V3
JP1
JP2
JP3
V1 V2 V3
JP1 JP2
JP3
JP2
JP1
JP4
V1 V3 V2
JP3
ONOFF
ORRS ORRA ORRD
3
ORRS and ORRA receivers : Switch on the receiver
ORRD receiver : go to the next step
DRAFT a