To Next Page

To Previous Page

VT X A12 | Rigging Manual

STEPS:

• Lower the next A12 cabinet on top of the ﬁrst enclosure and make sure all 4 corners are aligned and the rigging arms

are engaged

• Use the 4 Quick Release Pins (2 on each side) and secure the A12 cabinet to the A12 below

• Set the cabinet side angle to the 10-degree (STORAGE) position and make sure the red locking lever is in the locked posi-

tion

• Repeat this process until all 4 cabinets are set on the VTX A12 VT

Other manuals for JBL VTX A12

Questions and Answers:

Need help?

Do you have a question about the JBL VTX A12 and is the answer not in the manual?

General