VT X A12 | Rigging Manual
7
2 - SAFETY
2.1 - SAFETY INSTRUCTION
1. Read these instructions
2. Keep these instructions
3. Heed all warnings
4. Follow all instructions
5. Do not expose the product to direct rain or sea spray
6. Clean only with a dry cloth
7. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus that produce heat
8. Only use attachments / accessories specified by the manufacturer
9. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is
used, use caution when moving the cart / apparatus combination to avoid injury from tip-over
10. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such
as liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does
not operate normally, or has been dropped
11. Contact JBL Professional for advanced servicing issues
12. CAUTION - DO NOT PERFORM ANY SERVICING UNLESS YOU ARE QUALIFIED TO DO SO
13. Prolonged exposure to excessive SPL can cause hearing damage: the loudspeaker is easily capable of generating sound pres-
sure levels (SPL) sufficient to cause permanent hearing damage to performers, production crew and audience members. Cau-
tion should be taken to avoid prolonged exposure to SPL in excess of 90 dB
14. Read the System Rigging Manual before installation and use of the product
2.2 - GENERAL HARDWARE INFORMATION
Any hardware used in an overhead suspension application must be load rated for the intended use. Generally, this type of hardware
is available from rigging supply houses, industrial supply catalogs and specialized rigging distributors. Local hardware stores do
not usually stock these products. Hardware that is intended for overhead suspension will comply with ASME B30.20 and will be
manufactured under product traceability controls. Compliant hardware will be referenced with a working load limit (WLL) and a
traceability code.
2.3 - ATTACHMENT TO STRUCTURES
A licensed Professional Engineer must approve the placement and method of attachment to the structure prior to the installation
of any overhead object. The following performance standards should be provided to the Professional Engineer for design purposes:
Uniform Building Code as applicable, Municipal Building Code as applicable, and Seismic Code as applicable. The installation of the
hardware and method of attachment must be carried out in the manner specified by the Professional Engineer. Improper installation
may result in damage, injury or death.
To Next Page
Loading...
Need help?
General
